Olympia CPD 3212 T Instruction Manual download pdf (Page 7)

. Starting up

.2 Unpacking and assembling

onnection to power supply:

- Check that the data on the data plate coincides with the local vol-

tage before connection calculator to power supply.

Connect calculator to power supply.

nserting the paper roll (Art. No. 06.860.1115):

- Fit the paper roll holder

- Roll out paper, leading edge to the bottom, into the guides

Turn calculator on

- Paper is drawn into paper slot

- Feed paper as far as possible until it stops at the rear opening

Use to insert the paper further

Turning ON / OFF:

hen turned on, the calculator is ready to operate.

At least 3 seconds should elapse between turning on and off

again.

B.3 General information

Accumulator:

Products, quotients and individual value can be totaled and stored

n the accumulator. Multiplication and division are ignored.

Entries:

Value and sub-totals are transmitted directly to the accumulator via

the addition and subtraction keys.

Constants:

The multiplicand, divisor, basic value or percentage, including the

subsequent function, are automatically retained as constants.

Repeat value:

Using the basic calculation modes, a value can be repeatedly

used as often as required.

Paper roll printout:

The decimal place is printed as a point.

Examples:

Entering values and calculation methods:

- Addition / Subtraction (a+b+c+)

Result via

- Multiplication / Division (axb앦c=)

Result via

Triad group symbols (commas) shown in display:

Values to the left of the decimal point are divided by triad symbols.

Example:

Capacity overflow:

When results exceed 12 full digits “ERROR” is printed out,

an “E” appears in the display and the keyboard is blocked for

entry. To release the keyboard;

press: or .

Memory block:

The memory will not accept a value which would exceed the me-

mory capacity. The memory contents remain unaltered.

Item counter (Switch position):

When activated a 3 digit item counter is provided for the accumu-

lator and for the memory.

By pressing and or and the number of additions

and subtractions are counted.

The number of item is printed on requesting sub-totals or final to-

tal. Example:008 = 8 items.

Pressing the final total key clears the counter.

tored rates retained:

The stored rates of conversion, tax and % will be retained even if

the calculator is turned off.

he 11 pre-programmed fixed Euro rates are available for different

countries (refer “Currency code table” page 29.) and are originally

installed in the calculator.

Currency conversion:

- The conversion rate consists of 6 significant figures with the deci-

al points.

- Additionally, 5-currency conversion rates can be programmable

nd stored.

- To convert between ʻ1 st currencyʻ and ʻ2 nd currencyʻ through

conversion rate, the 1st currency and the 2nd currency will be se-

ect among ʻ Euroʼ , ʻo riginally installed 11-currencyʼ and ʻsto red 5-

currencyʼ.

- Conversion rate is printed out with the symbol of R#.

Euro currency can be printed out with the following symbol mark:

ax Rate:

- Tax rate consists of 6 significant figures with decimal point.

- Tax rate is printed out with the symbol of RT.

Automatic %+ calculation (percent add-on):

- Automatic %+ calculation can proceed with user stored % rate or

ntry % rate.

- The user stored % rate consists of 6 significant figures with deci-

mal point.

Stored % rate is printed out with the symbol of R%.

B.4 Keyboard summary

The keyboard has an input buffer which enables all entries, re-

gardless of speed of input, to be proceeded in order of input.

Total clearance

- The complete calculation process is cleared. Memory con-

tents are retained.

- The stored rates are retained even after depressing this

key.

Recall item counter

- Press once:

Recall number of added items

- Press twice, after recall of final sum or sub-total:

Recall arithmetic mode average of item addition and sub-

traction.

Non-add key

- Date or number printout.

Correction key

- Clear entered value.

Algebraic sign change key

- To specify a positive or negative value.

Digit keys

- The values entered appear in the display.

Decimal point key

Subtraction key

Addition key

Sub-total key

- Recall accumulator / item counter contents

Final total key

- Recall and clear accumulator / item counter contents

Percent key

Together with :

- Recall percent value.

Together with and or :

- Recall the value plus or minus the percent value.

Division key

Multiplication key

앦

008

600.00,

–

쏄

◊

–

+/-

앖

1 234 567 890.12 +

1,234,567,890.12

CE C

+ – M+ M–

쏄

–

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Comments to this Manuals

No comments

Olympia CPD 3212 T Instruction Manual Page 7

Comments to this Manuals

Related products and manuals for Calculators Olympia CPD 3212 T