Olympia ECS 510.3 CCD Operations Instructions download pdf (Page 25)

100

11 Troubleshooting

Problem Diagnosis & Cause Solution

Is the power plug connected

properly in the power socket?

Connect the power plug to the

power socket properly.

Is the On/Off switch set to

OFF?

Set the On/Off switch to its ON

position.

Is the ECS function activated? Press the ECS button so that it

lights up blue.

Has the device been

assembled properly?

Ensure that the waste bin has

been inserted properly.

Device does not

work

Does the motor fail to start

when material is fed in?

Slide the material in the

respective infeed slot so that it

makes contact with the sensor

in the middle.

Device no longer

functions after a

longer period out

of service or

stops during

operation

Was the device shutdown for a

longer time? Is the surface of

the device warm? The

permissible operating cycle

has probably been exceeded.

First of all, disconnect the

power plug from the power

socket and allow the motor to

cool down to room temperature.

For information on the operating

cycle, refer to Chapter

"Technical Data".

Overloading

(material jam)

Have you exceeded the

permissible material capacity

(refer to Chapter "Technical

Data")? Has the material been

fed in askew?

Clear the material jam, refer to

Chapter "Clearing a material

jam".

Note: If you cannot clear the fault yourself, contact your dealer or call the

Olympia hotline.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 99 100

Comments to this Manuals

No comments

Olympia ECS 510.3 CCD Operations Instructions Page 25

Comments to this Manuals