Olympia ECS 510.3 CCD Operations Instructions download pdf (Page 19)

4 Starting Up

1. Remove the device carefully from the packaging.

Attention: The underside of the cutting mechanism attachment has sharp edges. Risk

of injury!

2. Place the device on a level surface.

3. Position the device near a power socket. However, do not position it near a source of

heat or water.

4. Insert the waste bin.

Note: The shredder only operates when the original waste bin is inserted cor-

rectly.

5. Set the On/Off switch to its OFF position.

6. Connect the power plug to a power socket.

Note: Pay attention that the power cable is laid so that people or pets do not walk

over it or that other objects can be set down on it. Pay attention to the in-

formation regarding power supply on the rear side of the device for the

necessary precautions.

Safety information: For reasons of safety, the power socket to which the

shredder power plug is connected must be near to the

device and freely accessible so that the power supply can be

disconnected quickly in an emergency!

5 Operation

Note: The recommended capacities stipulated in Chapter "Technical Data" must

not be exceeded, otherwise material will jam! Do not forget that the thick-

ness of the paper increases when folded, as a result of which the recom-

mended sheet capacity can be exceeded. Also reduce the quantity of pa-

per when shredding coarse paper.

5.1 Switching the device on

● Set the On/Off switch to its ON position.

The green “power on” lamp lights up.

The device is ready to operate.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 99 100

No comments

Olympia ECS 510.3 CCD Operations Instructions Page 19