Olympia 3113 Instruction Manual download pdf (Page 14)

Current consumption: 1 A

Power consumption: 2 :

Dimensions (LxWxH):  x  x 5 mm

Weight: Approx.  g

Hot Laminating

1 Connect the power cable to an easily accessible, standard electrical

socket.

Caution: Check that the voltage specifications of the unit correspond

to that of your power supply network (220 - 240 V, 50 Hz).

2 Use the on/off switch on the right of the appliance to switch on:

"+27", the red display lamp shows.

3 The drive motor for the transport rollers starts up. The correct operating

temperature is reached after about 3-5 minutes and the green display

lamp shows.

4 Insert the document to be laminated in the pouches so that there is a

margin of approx. 3 - 5 mm to the edge of the foil on all sides.

Caution: Only use foil intended for hot laminating.

5 Insert the foil containing the document in the laminator's insertion slot.

Insert the ready closed side of the pouch first.

Note: To prevent the laminating foil from creasing, never insert the

open end of the foil pocket in the insertion slot of the laminator first. When

inserting the foil, observe the instructions on the insertion slot. The laminat-

ing process occurs automatically.

Caution: The foil is very hot and soft when ejected following lamina-

tion. Therefore, handle the laminated product with extreme care.

Note: To flatten the laminated product, place a book or similar heavy,

flat object, on it.

Cold Laminating

1 Connect the power cable to an easily accessible, standard electrical

socket.

Caution: Check that the voltage specifications of the unit correspond

to that of your power supply network (220 - 240 V, 50 Hz).

2 Switch on the On/Off switch on the top, right-hand side of the unit:

COLD

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 53 54

No comments

Olympia 3113 Instruction Manual Page 14